kuangshanposui · 9 days ago
After many customers purchase Calcium Carbonate Limestone Machine, such problems often occur after a long period of use. Since the customer does not have a special understanding of the sand making machine, it is difficult to solve the problem in time when problems are encountered. The customer was very annoyed and greatly affected the production efficiency of the sand making machine and affected the income of the sand and gravel factory.First of all, the problem that every production line will not pay attention to is the installation of the equipment. The sand making machine should be level when installed. Even if the surface of the casting is not normal, it can be adjusted with eccentric rubber, otherwise the equipment will tilt. When rotating at high speed, the centrifugal force will deviate, the equipment will vibrate, and the material will be broken unevenly.Second, the problem of loading, feeding should be uniform, not the more food, the better. If the feed is too much at one time, it is easy to block the equipment cavity, which seriously affects the production efficiency. Third, the humidity of the material to be pulverized, for dry sand equipment, the sand making effect is very good for those materials with relatively low dry water content. However, when the water content of the material is too large, the machine will be slow and the viscous material will adhere to the inside of the machine, which will also block the discharge port.In fact, the above problems can be prevented. The customer shall maintain and maintain the equipment before and after the production of the equipment. Please read the instruction manual carefully during operation. All of these problems can be avoided.
You must first create an account to post.